ISO INTERNATIONAL STANDARD 11312 Second edition 2000-11-01 Photography Sheets of sensitized material for the pre-press industry - Dimensions and related requirements Photographie - Feuilles en materiau sensible pour I'industrie de preimpression Dimensions et exigences connexes Reference number ISO 11312:2000(E) ISO @ ISO 2000 py IHS under lic ted without license from IHS Not for Resale ISO11312:2000(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademarkof Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ Iso 2000 - All rights reserved py IHS unde ermittedwithoutlicense from IHS Not for Resale ISO 11312:2000(E) Contents Page Foreword. Introduction Scope 2 Normative references.. 3 Terms and definitions 4 Conditionsformeasurementofdimensions 5 Dimensions. 6 Squarenessandedgestraightness, 7 Identification of the sensitized side... 8 Packagemarking 9 Compliance AnnexA(informative)Dimensional stability Bibliography. ili d by IHS under license with se from IHS Not for Resale